Updated November 2026

Solar water heater installers are the people who size, mount, plumb and commission your system, and the quality of their work decides how well it performs for the next twenty years or more. This guide shows you how to find candidates, check their credentials, compare bids and spot problems before you sign. It is written for homeowners who are either hiring a pro or deciding how much of the job to handle themselves.

Know What the Installer Needs to Do

Before you call anyone, confirm the scope. A typical job covers a site assessment, collector mounting, piping runs, a storage tank connection, a pump or thermosiphon layout, controls and a pressure and temperature test. Some installers will also handle the electrical hookup and permit paperwork, and some will not. Ask for the scope in writing so you can compare bids on the same basis. The guide on Site Assessment for a Solar Water Heater: Sun, Shade, Roof and Space explains the measurements a competent installer should take on day one.

Shopping for one? See our guide: 5 Best Solar Batch Water Heaters for Homeowners (2026).

Check Credentials and Local Requirements

Start with licensing. Many states and municipalities require a licensed plumber or mechanical contractor for the hot water piping, and some jurisdictions require a separate solar permit. Ask each candidate for:

  • Current state or local contractor or plumbing license number
  • Proof of general liability and workers’ compensation insurance
  • Solar-specific training or certification, such as North American Board of Certified Energy Practitioners (NABCEP) credentials, if they are available in your area
  • Two or three references for completed solar thermal jobs, not just general plumbing

Confirm the license with your state contractor board directly rather than relying on a copy the installer provides. For permit and inspection rules, see Solar Water Heater Codes, Permits and Professional Review.

Compare Bids on Equal Terms

Collect at least three written quotes. Because the scope varies so much, a simple comparison table helps you see what is and is not included.

Item to compare What to look for
Collector type and count Named type (flat plate or evacuated tube) and the number of panels matched to your tank size
Storage tank Capacity, insulation rating and whether the tank is new or reused
Freeze and scale protection Stated method, such as drain-back, glycol loop or a freeze-tolerant design
Controls Differential controller with temperature sensors, and who programs it
Warranty Length for labor and for equipment, in writing
Permits and inspection Who pulls the permit and who schedules the inspection

If one bid is far below the others, ask what it leaves out. Missing controls, undersized piping or no pressure relief valve are common reasons for a low number.

Ask Technical Questions That Reveal Competence

A good installer will answer these without hesitation:

  1. How will the system handle freezing in your climate? (See Winterizing a DIY Solar Water Heater: Freeze Protection Options for the main approaches.)
  2. What is your plan for water quality and scale? Hard water needs attention. Water Quality and Scaling in Solar Water Heaters covers what to ask about.
  3. Where will the pressure relief and temperature relief valves discharge, and how are they rated?
  4. How do you size the collector area and storage for my household’s daily use?
  5. Will you commission the system and show me how to read the controller?

Vague answers, or a plan that relies on the homeowner to fix problems later, are warning signs.

Red Flags and Final Checks

  • Requests for a large cash deposit before any work or permits are filed
  • No written scope, or a quote that lists only equipment prices
  • Refusal to pull the required permit
  • Pressure to decide the same day
  • Installers who cannot explain how the system handles overheating on a sunny day with no draw

Common Mistakes

  • Hiring based on the lowest quote without checking what is included.
  • Skipping the license check and assuming the installer is covered.
  • Accepting a system with no clear freeze protection in a cold climate.
  • Letting the installer choose the controller without asking how it is programmed.
  • Failing to get the warranty terms in writing before the first payment.

FAQ

How do I find qualified solar water heater installers near me?

Search your state contractor board for licensed plumbing or mechanical contractors, then ask those firms whether they have solar thermal experience. NABCEP directories can also help you find certified practitioners.

Do I need a separate solar installer if my plumber is licensed?

Not always, but many plumbers have little solar experience. A licensed plumber who has completed solar thermal jobs is a strong candidate, and you should ask for references from similar installs.

Should I ask for proof of insurance from solar water heater installers?

Yes. Ask for a current certificate of general liability and workers’ compensation insurance, and confirm the policy is active with the insurer before work begins.

Conclusion

Good installation matters as much as good equipment. Verify licenses, compare written scopes and ask pointed technical questions before you choose a firm. A careful hiring process protects your investment and your warranty. Consult a licensed professional for any work involving gas, electrical or structural changes.

Graham Fisher

About Graham Fisher

Graham Fisher is part of our editorial team and reviews and edits our solar water heaters guides, checking product details against manufacturer specifications and owner feedback.