Fundamental Of Wood Burning Stove Parts

Normal 0 false false false EN-US X-NONE X-NONE


You will find fundamental wood  burning stove parts, these are provided listed below


Door Adjustment

Check the seal on the loading door with paper money. Open the door on a cold stove, place the bill throughout the gasketed spot of the door, then close and latch the door. Try to remove the bill by pulling. The bill really should not pull out quickly.


Door Glass

Contemporary wood heaters use a clear ceramic material instead of the tempered glass that older fireplaces employed. This ceramic material is generally called stove glass for simplicity. It won’t break with heat generated by wood burners, but it can break if the fasteners are over-tightened or if it’s struck hard with a poker or piece of wood.



Several stoves are factory enameled, finish that can’t be added later. Enamel is quite tough, even below heat stress, but may be broken by cracking. Touch up and enamel filler kits are accessible from stove dealers.



Firebrick is utilized in many wood stoves to protect steel or cast iron while growing firebox temperatures for greater combustion. Current EPA licensed wood heaters typically use a lighter, lower density brick for higher performance. When replacing such brick it’s important to replace with the same brick kind to maintain your stove’s efficiency.



Baffles in wood heaters reflect heat towards the fire, improve the length of the flame path and produce a chamber for secondary combustion, all of which are necessary for clean burning and high efficiency. They may be steel, cast iron, firebrick, ceramic fiber board or a combination of these supplies. Since they’re exposed to flame on both sides, baffles get very hot and may well fail more than time.


Air tubes

Stainless steel air tubes are applied at the top of the fire below the horizontal baffle in several current EPA certified stoves. The intense heat in this location can cause them to sag or disintegrate in time. The tubes are removable by undoing the fastener or turning to unlock the keyed ends. Substitute with factory parts and new fasteners.

If you want to read more about ventless gas fireplace inserts, please check my site at , so you can have more information’s about ventless gas fireplace inserts



Posted under Miscellaneous Content

Leave a Comment

Name (required)

Email (required)



More Blog Post

    All you need to know for a DIY Soalr System in Books and CDs on eBay

1978 Mother Earth News Magazine Number 51: Solar Water Heater

Solar Power Cooker cd 38 bks Water Heater Homesteading Pump Dryer Vol. 1 of 4

Solar Power Cooker CD ROM 38 Books Water Heater Homestead Pump Dryer Vol. 1 of 4

Detailed Guide on Making Solar Water Heaters: Making Cheap but Quality PVC Solar Water Heaters

As Advertised on eBay